I have a new Beelink SER9 MAX (AMD Ryzen 7 255, 64 GB RAM, 1 TB Crucial P310 NVMe). BIOS is Aptio 2.22.1293, version HPT.2xx.SERMP.V035.P8COM0C15.08.BLink dated 04/15/2026. I did a clean install of Windows 11 Pro (build 26300) in UEFI mode on a GPT disk. Windows runs normally with Secure Boot off.
What I see in the BIOS (Security tab):
- Secure Boot: Enabled, status “Not Active”
- System Mode: User, Secure Boot Mode: Custom
- Vendor Keys: Valid. Factory Key Provision: Enabled
- PK 1 key, KEK 2, db 4, dbx 245, all with source Factory
When I save with Secure Boot enabled, Windows does not start. I get the blue screen “Your device ran into a problem and couldn’t be repaired” with the log file SrtTrail.txt. If I go back into Setup and set Secure Boot to Disabled, Windows starts normally. I did not run any repair options.
Questions:
- Is Secure Boot expected to work on the SER9 MAX with the factory keys and Windows 11 Pro? Does it need Secure Boot Mode set to Standard instead of Custom?
- Has anyone seen this with BIOS 08, and did a different BIOS version fix it?
- Is there a Beelink-recommended order for enabling it (for example, restore factory keys, then enable, then reinstall Windows)?
I am not flashing any BIOS version until I know it is needed. Thank you for any help.