Thank you
All worked fine. One thing that wasn’t in the instructions is that when I completed the flash, the system advised I perform a G3 power cycle. For anyone who doesn’t know, it means to change the power failure reboot status.
Here are the instructions to correct it if you’re using your NUC for pfsense etc.
To perform a G3 power cycle on a Beelink mini PC, you need to access the BIOS settings and adjust the power management options.
Here are the steps:
Press the Del key repeatedly after powering on the mini PC to enter the BIOS setup.
Navigate to the Chipset page and select “PCH-IO Configuration”.
Select “State After G3” and set it to “S0 State”.
Press F4 and select “Yes” to save the configuration.
Cheers. 👍