Hello! I’ve been waiting for a long time for the firmware for Thunderbolt 4 on my GTi14 ultra 155H. What’s new in this firmware anx7406(2024-11-13)_2024-11-14_8-06-32? Please write changelog. I hope this will solve my problem of simultaneously powering the monitor and DisplayPort through one cable TB4.

Hi there, Here is the thunderbolt chip firmware https://url.bee-link.cn/2iJ1 here is the tutorial https://url.bee-link.cn/U50s

support1 I updated thunderbolt chip firmware on my GTi14 155H with T105-BIOS firmware and finally now my monitor Arzopa Z1RC works through one type-c cable!!! Thank you Beelink! You made my day! You guys are great!

Hi, Im using GTI14 185H with latest BIOS 201. How do I update the “anx7406(2024-11-13)_2024-11-14_8-06-32” via usb? I have followed the instructions document but it wont boot from the USB to update?

narumivtl You should simply enter the BIOS using the DEL key when booting and in the BOOT section select simply Launch EFI Shell and then enter the command: FS0: where FS0 - your usb flash drive

vitasonline Took me a while to figure it out, it was the last EFI selection as you said. Anyways I have updated and finally! my USB C portable monitor now works with a single cable!!! so happy!

I followed the instructions for “anx7406(2024-11-13)_2024-11-14_8-06-32.zip” but it does not load anything it keeps bouncing back to choose boot drive screen. How do I get this to work? In the future all of these update should be available to be completed inside windows instead of bios screen. Most users would not be capable of completing the instructions.

lud14 Did you put all the files into the root directory of the USB flash drive ? Could you please send us a picture to show the files on your USB drive ?

lud14 Hello! Watch my video, I show you how to flash it

GTi14, SEi14 Thunderbolt Chip Firmware Flashing

dahjah

Well al worked great yesterday, I shutdown a few times restarted a few times throughout the day just making sure all was well, and it was until this morning. This morning the thunderbolt port isn’t working again after shutting down over night.

support1

dahjah Hi there, Please turn off the PC , unplug the power supply and other USB devices, then put the pin in the CMOS pinhole and press it for about 10 seconds , restart the PC after ten minutes.
Here is the tutorial https://url.bee-link.cn/5FdW

Joseitogreg

The firmware update is done for efi shell opcion no for efi usb device in the boot menu after pulse f7

support1

Joseitogreg Hi there, thanks for your sharing

Twinklekapoor

It appears the EFI USB Device option is not appearing. Try to see if the USB drive is properly formatted, that USB boot is turned on in the BIOS, and try resetting or updating the BIOS. Let me know if that works!

yasdum

Image description
I have gt14i, and get ic 0 active section error 3
IC 0 update error 7. So have can i flash the firmware?

Hankydooodle

yasdum I encountered this same error yesterday when I tried to flash. Were you able to get it working or still running into the same issue?

yasdum

Hankydooodle Still the same.

« Previous Page