support1
That “fs3:” seems to have worked so far. The thunderbolt port opened up and all connected is working again.
Thanks!

Well al worked great yesterday, I shutdown a few times restarted a few times throughout the day just making sure all was well, and it was until this morning. This morning the thunderbolt port isn’t working again after shutting down over night.

dahjah Hi there, Please turn off the PC , unplug the power supply and other USB devices, then put the pin in the CMOS pinhole and press it for about 10 seconds , restart the PC after ten minutes.
Here is the tutorial https://url.bee-link.cn/5FdW

The firmware update is done for efi shell opcion no for efi usb device in the boot menu after pulse f7

Joseitogreg Hi there, thanks for your sharing

It appears the EFI USB Device option is not appearing. Try to see if the USB drive is properly formatted, that USB boot is turned on in the BIOS, and try resetting or updating the BIOS. Let me know if that works!

I have gt14i, and get ic 0 active section error 3
IC 0 update error 7. So have can i flash the firmware?

yasdum I encountered this same error yesterday when I tried to flash. Were you able to get it working or still running into the same issue?

Hankydooodle Still the same.

yasdum
Still the same error 7

Beelink User Hi there, glad to hear that.

vitasonline
Hi there,

This new firmware has something to do with the thunderbolt. Some users have issue when they use the thunderbolt, such as blue screen . After updating this firmware, it can solve the problem. And you are right that this firmware also solve the problem of high power consumption during shutdown and hibernation. I name it new compare with the old one GTI14-Thunderbolt-Firmware-update-tutorial-.doc, which cannot solve the blue screen issue when connecting to the thunderbolt port.

Добрый день! Нужна прошивка для программатора, можете скинуть дамп на почту. GTi14-l-321tbvk0w64pr, sn:3850836n20,mb AWZ_gti14_v1.0
При прошивке отключилось питание.
Good afternoon! You need firmware for the programmer, you can send a dump to the mail. GTi14-l-321tbvk0w64pr, sn:3850836n20,mb AWZ_gti14_v1.0
The power went out during firmware.

Alexei1145 Hello there,

Please press delete key as soon as you turn on the PC, so that you can go to BIOS. Please send us a picture of the Main page.
We will check if you need to update the BIOS.

support1 Добрый день! Нужна прошивка именно для программатора , до этого была прошивка GTi14-T106. Нужен дамп слитый с микросхемы. Или для прошивки микросхемы 25q256. Прошивка по usb не подойдет. Пк на данный момент не включается.
Good afternoon! The firmware is needed specifically for the programmer, before that there was the GTi14-T106 firmware. We need a dump merged from the microcircuit. Or for the firmware of the 25q256 chip. USB firmware won’t work. The PC is not turning on at the moment.

Alexei1145
Hi,Please check your private discussion,we had send you the GTi14-T106 link.